My progress is slow but steady.
A project I wanted finished in spring 2019, is far from finished.
Here is a update:
I mounted two bends to the bottom bracket to finish of the frame. It slow progress because all the cables will be routed through the frame.
The black cable taped to the frame will go through a hole behind the torque sensor and up to the controller
mounted below the head tube and the e-bike display is mounted above the controller, the buttons for the display is hidden in the gusset. When it's finished, all the cables from the controller will also be hidden in the gusset.
So the rear frame is now finished, just need to tidy up a lot of welds.
The bike is wobbly on take of, I presume that's the trait of a chopper, but ones you get going its fine.
My next move is to wire up the motor to see if it's makes the ride worse or better.
My first E-bike so if anybody know what minimum cables (sensors) are needed for my setup, let me know.