Welded them in place. Need to clean it and close the gaps on the side of 2 in the front.
I was afraid that I would destroy them to much and had to sand them a lot to get the bearings in. But even the one in the rear, is almost all clean inside. Noting I can't remove with a bit of sanding. Need to clean the welds a lot and probably close the holes that will show up. But it's getting dark early, so I had to stop.
First clean it now and as that is done, put some welds over it. That will be easier.
I check it and alm are mounted as they need to be.
The 3d printed parts, did their work. 2 melted a bit, but I expected that. I don't need them any more.
Also mounted the rear part for the seat.
I have now 2 to 3 weeks the time to clean it all and put nice welds on it. After that, I hope to have my last few parts, so I can finish the build.
I was afraid that I would destroy them to much and had to sand them a lot to get the bearings in. But even the one in the rear, is almost all clean inside. Noting I can't remove with a bit of sanding. Need to clean the welds a lot and probably close the holes that will show up. But it's getting dark early, so I had to stop.
First clean it now and as that is done, put some welds over it. That will be easier.
I check it and alm are mounted as they need to be.
The 3d printed parts, did their work. 2 melted a bit, but I expected that. I don't need them any more.
Also mounted the rear part for the seat.
I have now 2 to 3 weeks the time to clean it all and put nice welds on it. After that, I hope to have my last few parts, so I can finish the build.