Does anyone know where I can buy ready made axle flanges in the U.K.? the plans I bought said they are now available on the AZ website but I can’t find them. Alternatively 2.5 inch washers in 1/8 thickness would work also.
Unlikely ?Does anyone know where I can buy ready made axle flanges in the U.K.?
About 10 years to late I am afraid .the plans I bought said they are now available on the AZ website but I can’t find them.
Nice but to far to pop in and rummage through my scrap stuff ...I am in Devon, and have the plans for a warrior and Aurora,
Yes any delta is simpler than a tadpole.most likely going to go with the aurora first as it looks slightly simpler.
probably be blunt before you cut enough , a angle grinder as the tutorial is quicker and easier , when you have worn the cutting disc down just spanner on another [ nice and cheap ]I have considered getting a hole saw and cutting through sheet steel, but not sure if this would work.
Plenty assume 1/16" = 1.5mm 1/8" = 3mm 1/4" = 6mm etc close enough for rock and roll ...I only seem to be able to find 3 mm sheet steel, will that be close enough to 1/8 inch?