Hi all
So despite my protestations in this thread :- the sap is rising ...
A new bike has been started !
A loose copy of this :-
A ZOX S-frame 20" x 20"
This is a wooden mockup to see if all the bits fit and I can reach the pedals....
The seat will be higher and it will have a single side mounted rear wheel , groovey or what !
have no idea where seat will end up , except prehaps further forward.
Realised I can raise the pedals considerably as I am comfortable with them at least 15 cm above the seat , however I can't sort the front end out until I have a set of forks ?
So cut some steel ! the piece for the rear wheel to mount on , a over long main boom and a piece to mount the head tube in also over long.
I cleaned up my truncated forks to lengthen the legs.
Progress soon I hope.
all the best Paul
So despite my protestations in this thread :- the sap is rising ...
A new bike has been started !
A loose copy of this :-
A ZOX S-frame 20" x 20"
This is a wooden mockup to see if all the bits fit and I can reach the pedals....
The seat will be higher and it will have a single side mounted rear wheel , groovey or what !
have no idea where seat will end up , except prehaps further forward.
Realised I can raise the pedals considerably as I am comfortable with them at least 15 cm above the seat , however I can't sort the front end out until I have a set of forks ?
So cut some steel ! the piece for the rear wheel to mount on , a over long main boom and a piece to mount the head tube in also over long.
I cleaned up my truncated forks to lengthen the legs.
Progress soon I hope.
all the best Paul