DannyC's latest activity

  • DannyC
    I found that I could reach 1/3rd of the circumference at a time, so I welded, let cool while firmly clamped, then rotated...
  • DannyC
    Is it a "magic" trick involving numbers; where the "Victim" chooses a number without telling you what it is and magically that's the...
  • DannyC
    When I did this to produce 12mm Stainless track-rods I was advised by Sandman to do the following: Grind the ends you want to weld...
  • DannyC
    DannyC replied to the thread Golden rules of tidying ?.
    I want to add two rules. Addition 1. Never, ever, ever allow your significant-other to do any "tidying" of your space. You will never...
  • DannyC
    DannyC replied to the thread Solid Tyres.
    I think you very much "dodged a bullet" there. ;)
  • DannyC
    DannyC replied to the thread Any down side to using 1" tube?.
    I believe @FrankCrank uses 2 x 1 stainless on his creations. The problem with a trike and a vertically oriented spine might be...
  • DannyC
    DannyC replied to the thread Any down side to using 1" tube?.
    38mm or 40mm in 16 gauge is fine for most situations 50mm is a bit OTT, but can be used. I had my first made in 40mm x40mm @ 2.5mm...
  • DannyC
    DannyC replied to the thread Another DIY Chain Whip/Wrench.
    Very God-Fearing them Germans. Day of rest/peace etc. We used to be like that in the UK (when I was a child) and supermarkets would...
  • DannyC
    DannyC replied to the thread Any down side to using 1" tube?.
    For the main parts of a frame, yes, unless it is used in a scaled-down model for a non-obese child.
  • DannyC
    DannyC reacted to Popshot's post in the thread Anyone own one of these ? with Like.
    I like the tip about a rubber end to the main clamp for angled cuts. So ovbious I hadn't seen it - doh! I'll do that with mine. Thanks.
  • DannyC
    DannyC replied to the thread Anyone own one of these ?.
    Yup, the variable angled stop doesn't (stop that is) at the angle you set unless you also do up its pivot bolt firmly (a bit of a faff...
  • DannyC
    DannyC replied to the thread So what's next?.
    I think the rider is on the wrong-side of the pivot, but there are some great ideas at work there in the front triangle dept.
  • DannyC
    DannyC reacted to stormbird's post in the thread So what's next? with Like.
    Dan What about a slimmed down version of this ? Organic engines even you should be able to get your pudgy legs around this wheel ...
  • DannyC
    If you are adding a mid-drive like a Bafang or a hub-drive, then these are both possible on the Delta Wolf or the Aurora.
  • DannyC
    Hello Michal, All of the plans for Atomic Zombie Recumbent trikes are to found HERE. From your introduction I would suggest either the...
Top