Kevin... I have measured for reach to the switches. It is only a minor stretch where they are at the moment.
Nothing I can't live with. But this is not the final design, yet.
I worked on modifying the steering mechanism.
The new design is on the right.
I wanted to clean up the pivot point that was to be on the outside of the frame.
So I slide everything over to the right and centered the pivot points in the middle of the frame.
One attached and the other free moving.
I will have to measure travel distance, so as to determine each arm/lever length.
Looking at the weld bolts, I just remembered I have some grade 8 shoulder bolts that just might work for this.
Nothing I can't live with. But this is not the final design, yet.
I worked on modifying the steering mechanism.
The new design is on the right.
I wanted to clean up the pivot point that was to be on the outside of the frame.
So I slide everything over to the right and centered the pivot points in the middle of the frame.
One attached and the other free moving.
I will have to measure travel distance, so as to determine each arm/lever length.
Looking at the weld bolts, I just remembered I have some grade 8 shoulder bolts that just might work for this.